CY8CKIT 030 DRIVER

Follow the instructions to uninstall. There are no specific hardware connections required for this project because all connections are hard wired on the board. The product detailed below complies with the specifications published by RS Components. A caveat to this is that there is no opamp available on this port; therefore, opamp based designs are not recommended for use on this port. RoHS Certificate of Compliance. After making these changes, you can make a boost convertor based design by making the appropriate configurations in the project.

Uploader: Makasa
Date Added: 3 May 2012
File Size: 14.24 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 79416
Price: Free* [*Free Regsitration Required]

Click the File icon and then click Open. CapSense Slider Figure Code protection cy8ckih constantly evolving Cypress are committed to continuously improving the code protection features of our products.

1 pcs x CY8CKIT-030A 8051 PSoC 3 Development Kit CY8CKIT 030A

This project uses the LCD for display; therefore, ensure that it is plugged into the port. The slider elements are connected to pins P5[0: Can be achieved, but is an invalid condition because the PSoC 3 silicon performance cannot be guaranteed.

GND on the board, but are provided for expansion boards designed for analog performance.

This also results in change in the period of the sine wave fed into LED4, which can also be observed. Copy your embed code and put on your site: Hardware The following figure shows the pin mapping for the port.

We, the Manufacturer or our representatives may use your personal information to contact you to offer support for your design activity and for other related purposes.

Thank you for your feedback. When you touch either of the buttons, the corresponding button’s state changes on the LCD. It can be purchased from the Cypress Online Store. The following block diagram shows the structure of the power system on the board.

CY8CKIT Price & Stock | DigiPart

By clicking the accept button below, you agree to the following terms. There are no specific hardware connections required for this project because all connections are hard wired on the board. The product detailed below complies with the specifications published by RS Components. Cypress is willing to work with the customer who is concerned about the integrity of their code. The two grounds on this port help to keep it distinct even on this board until it reaches the GND plane.

Turning the potentiometer results in LCD cy8cjit change. Sending feedback, please wait If the board is already powered from another source, plugging in the programming USB does not damage the board.

Cypress Cy8ckit PSoC 3 Development Kit | eBay

The CapSense buttons are connected to pins P5[6] and P5[5]. The Manufacturers and RS reserve the right to change this Information at any time without notice. Save this item to a new parts list. You have chosen to save the following item to a parts list:.

The Cmod modulation capacitor is connected to pin P6[4] and an optional Rb bleeder resistor is available on P15[4]. The LCD also shows the slider touch position as a percentage.

Two LEDs out cy8ckitt the four are hard-wired to port 6[2] and port 6[3] and the other two are brought out on pads closer to the prototyping area.

Designed for use with the CY8CKIT-030 PSoC 3 … – Future Electronics

Save to an existing parts list Save to a new parts list. When the slider is touched, the corresponding finger position is displayed as a percentage on the LCD. Jumper Settings J10 setting and J11 setting.

This kit allows programming in two modes: Please enter a message. You agree that the Information as provided here by RS may not be error-free, accurate or up-to-date and that it is not advice. The CD is designed to auto-run and the kit menu appears.