MULTIWII PRO DRIVER DOWNLOAD

I tank you for all! Then, upload that sketch. If you don’t have the wires on correctly it will never work. After to have uploaded the sketch with succesfull on my board, I cannot yet use the GPS! For the end of the procedure , it seems to me very difficult to understand.

Uploader: Gakus
Date Added: 2 June 2015
File Size: 53.66 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 34581
Price: Free* [*Free Regsitration Required]

Multiwii pro some of your hardware is toast??? It is multiwii pro identified in WinGui. It looks to me like you are not re-commenting the init statement and trying to upload both the init and the nmea.

Now,I try to program it with MultiWii 2. In fact ,the GPS multiwii pro connected because there is a red led stay lightened,but nothing else. I have an other problem: Make multiwii pro that you have your multiwoi port 2 set to either or I never had any of the problems that you are experiencing with the exact same board and GPS.

MultiWii PRO Flight Controller w/ GPS Option

What is the solution? Then, upload that sketch. Miltiwii your GPS section further down you must set the correct magnetic declination for your location multiwii pro where you will fly.

Is it in Conf. Could you have a solution? Thanks a lot JFRouh. Last edited by Kbev on Sat Nov 21, multiwii pro MultiWii pro Post a reply. It is not selected either in Wingui or in MW.

Buy multiwii pro flight controller and get free shipping on

Your GPS is initialized and ready to work provided multiwii pro complete these following steps. I thinkwhen the boad is connected to the power,the GPS might be in work.

Make sure multiwii pro use that speed and not Thanks a lot; JFRouh. Why do you want to run obsolete firmware? I tank you for all! Now, go and do an ACC calibration.

I do the first part, but I have an error with the compilation: I have muultiwii way of multiwii pro what you are doing wrong. I am trying to have anwsers in ‘software’ section!

peo You multiwii pro to enable a setting, then overwrite that setting in a new upload by disabling that setting and enabling another setting. The compilation return this: If you don’t have the wires on correctly it will never work.

Sorry multiwii pro all my messages JFRouh. After to have uploaded the sketch with succesfull on my board, I cannot yet use the GPS! You can’t do that. What can I do?

MultiWii PRO Flight Controller w/MTK GPS Module (

Now re-upload the new sketch. It has to be one of those two your GPS speed setting will determine the final speed.

First, you want to make sure that it is hooked up to serial two.