You are commenting using your Facebook account. Thank you Like Like. But at that time, it was somehow not working for me, and I had not enough time to find out what the problem was. In many cases I do a full erase-flash-debug cycle: I think it is the later, as I have not touched that board for a very long time. What do you think? Downloading the MByte zip file and installing the update will take a while.

Uploader: Mejin
Date Added: 1 May 2004
File Size: 39.50 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 63682
Price: Free* [*Free Regsitration Required]

The first thing i usually think about when it comes to creating a new board is: It is one of these long weekends which allow to catch up on many things. Hi Bernd, there are a few zero ohm resistors on the board e. This site uses Oabdm to reduce spam. A single BDM interface for programming and debugging of the following targets: I’m still on a quest to get a working Kinetis development environment in a VirtualBox Virtual machine, preferably under Ubuntu.

And within minutes, I have the application running on the board, osbrm the virtual bridge on COM Trial-and-error determination of communication speed for earlier HC12 targets.

Error connecting to the hardware. Could you fix this? I had to learn it the hard way: Board with LEDs on as normal.

In order to copy a project with all the settings, some knowledge about the internals of the project structure is required, which is the topic of this post. With this I did some tests using the Tower boards, including the Kinetis one. But then to my surprise I got this dialog:. Log in to follow, share, and participate in this community.

I have seen recently a growing number of issues with XP especially with driver installations.

Dialog asking to remove the jumper again. This one was one of the first Tower boards available, and very similar to the TWR one: This site uses Akismet to reduce spam.

What is difference between OpenSDA and OSBDM?

So less is more, and if it is just about the UART. Oabdm on Thu Jan 15 The most difficult part is locating the bootloader jumper location: If it does not, it is really bad: Now I can use a single connection for power, debug and terminal connectivity.

And how to install the drivers manually if something is not going well. The OSBDM design not only provides debug communications but allows power to be provided to the Freescale processor under test.

This tool uses JavaScript and much of it will not work correctly without it enabled. With little help and preparation, a copy a project is not that difficult to do.

USBDM: USBDM (combined TBDML/OSBDM code) for JM32/60

Jumper on Bootloader Header. Regards, Bernd Like Like. And if the firmware is too old, then the debugger cannot automatically update the firmware. Another good reason always to have a warmed up soldering iron within your reach. After everything is installed: This can have advantages when connecting to high speed targets as the alternative clock may operate at a lower speed.

When I use CodeWarrior v If you want to revert to the version without the update, simple delete the updated installation and rename the one without the update again.